Product Manual

74
Programming Data Outputs
The reader is supposed to know how to run the Web Server
(see Getting Started With the Web Server on page 45) before
reading this section.
Remember, when using the Web Server, at any time you can
access context-sensitive help by pressing this key:
• Go to Receiver > I/Os > Input Setup and Output Messages.
In the right-hand part of the Web Server window, all
receiver ports are listed, and for each of them, you can
read the message or messages currently programmed to
be output on this port at the specified data rate(s).
• To add or modify a message on a port, click on the line
corresponding to that port. This updates the left-hand part
of the window from which you can add or modify as many
messages as you wish.
You may need to re-select the matching category in the
upper field to access the desired message. For example if
NMEA and ATOM messages are programmed on a given
port, re-select ATOM in the upper field to access the
definition of the ATOM messages. Same applies to NMEA
messages.
For any further question about how to handle messages,
please refer to the on-line Help.
Rover Output
Messages
You will typically use a rover to generate NMEA messages to
deliver its results (see complete list on page 77). Note that
part of these results are also visible on the receiver front
panel and in the right-hand section of the Web Server
window.
You will typically use the receiver to output the following
NMEA messages:
• One GNSS antenna used:
Output NMEA Message
Position (Autonomous, SDGPS, RTK,
Hot Standby RTK or RTX)
GGA
Relative RTK VCR