Product Manual

(Rover) • Fourth line (see examples on the left):

– For a rover, current reception sensitivity (low, medium

or high), followed by “FEC” (Forward Error Correction)

and “SCR” (Scrambling) if these two functions are

enabled, followed by the type of modulation used and

“REP” if the radio is used as a repeater.

(Base) – For a base, radiated power (500 mW, 1 W or 2 W),

followed by “FEC” (Forward Error Correction) and

“SCR” (Scrambling) if these two functions are

enabled, followed by the type of modulation used.

If the fourth line does not fit on the screen, it will be

automatically scrolled from right to left.

The Radio screen being displayed, press the OK (central)

button to enter the edit mode. From there, you can turn on or

off the radio.

If you highlight the third option (Settings) and press OK, you

can edit each of the following radio parameters. After setting

a parameter, press OK to save it and then press the down-

arrow button to access the next parameter:

• Channel/Freq: Depending on how the radio was set up, you

can choose a channel and corresponding frequency from

a list of preset channel/frequency choices.

• Protocol/Linkspeed: Possible choices are:

• Sensitivity (Low, Medium or High)

• FEC (ON or OFF)

• Scrambler (ON or OFF)

• Current power when the radio is used as a transmitter

(500 mW or 2 W).

• Repeater mode (ON or OFF)

25 kHz Channeling 12.5 kHz Channeling

TTALK@4800 TRANS@4800

TTALK@9600 TRANS@9600

TTALK@16000 TMARK@4800

SATEL@19200 TTALK@4800

TT450S@4800 TTALK@8000

TT450S@9600 SATEL@9600

TMARK3@19200 TT450S@4800

TFST@19200 TMARK3@9600

TRANS@4800 TFST@9600

TRANS@9600 ULINK@4800

TRANS@19200

TMARK@4800