Product Manual

Port B can be switched to RS232 or RS422 using the

$PASHS,MDP command. RS232 inputs/outputs are typically

± 10 Volt asymmetrical signals with respect to ground.

RS422 inputs/outputs are 0/+5 Volt symmetrical signals

(differential lines).

NOTE: All signals are electrically isolated from the chassis

ground and power source.

Serial Port F

On rear panel. A standard RS232 serial port + CAN bus +

1PPS output

A 9-C connector of the type Harting DB9M 9cts 09-67-509-

7658, fitted with a sealing cap.

The 1PPS output is similar to a standard TTL output (0/+5 V):

• VOH Min= 4.5 V at IOH = + 4 mA

• VOL Max= 0.4 V at IOL= - 4 mA

NOTE: All signals are electrically isolated from the chassis

ground and power source.

Pin Signal Name

1 CAN POWER (IN)

2RX (IN)

3TX (OUT)

4CANH

5 GND-F

6NC

7CANL

8NC

9 1PPS (OUT)