Product Manual

2 Basic setup and operation
l on the Desktop taskbar. The battery status appears on the right side of the taskbar.
Tap the battery icon for information about the charging and battery status, including
the charge percent remaining.
l on the battery. Press the button on the battery to check the battery charge level. You
can check the charge level of the battery in this way when the battery is inserted in the
device, or when it is not.
The LEDs on the battery will show one of the following:
l
= No LEDs are lit: <4 %
l
= 25 %
l
= 50 %
l
= 75 %
l
= All LEDs are lit:100 %
LED charging status
The charging status is shown with an LED on the front top left corner of the display.
l ☀ Red:charging error. It can take the device approximately 30 seconds to recognize a
bad battery and indicate a charging error.
l ☀ Orange: Ranger 7 data collector is charging.
l ☀ Green: Ranger 7 data collector is fully charged.
l ☀ Green - Flashing: Ranger 7 data collector is in Sleep state.
Turning the device on
To turn on the device, press the Power key. The Spectra Precision logo appears. Swipe up
on the touchscreen to enter a PIN or password.
Saving battery power
To save battery power, set the screen to turn off when you haven't used it for a length of
time. This state enables your device to resume quickly when you want to start working
again.
To further save battery power, set the device to go into Sleep state when you haven't used
it for a length of time. Sleep state saves your work and turns off the device. When you start
up the device again, you are back where you left off.
To set the screen turn-off time and the Sleep state time, go to Settings / System / Power
&sleep.
Spectra Precision Ranger 7 Data Collector User Guide | 34