Product Manual
2 Basic setup and operation
5. Close the SD/SIMbay door, and tighten the screws.
6. Replace the module bay covers, or if using modules, re-attach them. See Using
EMPOWER modules, page 63.
Attaching the handstrap
Attach the handstrap to the left or the right side of the device, according to your personal
preference. To ensure a good fit:
1. Thread one end of the handstrap ribbon through the top handstrap slot; thread from
the center of the device toward the top of the device.
2. Pull the end of the ribbon back towards the center of the handstrap and feed it up,
over, and down through the lock buckle on the handstrap and pull it tight.
3. Thread the ribbon at the other end of the handstrap through the bottom handstrap
slot; thread from the center of the device toward the bottom of the device.
4. Pull the end of the ribbon back towards the center of the handstrap and feed it up,
over, and down through the lock buckle on the handstrap and pull it as tight as is
comfortable for your hand.
If required, use a small blunt tool to push the ribbons through the handstrap slots on
the device. Do not use a sharp tool.
Spectra Precision Ranger 7 Data Collector User Guide | 27