Product Manual

52
Advanced GPS Page
Return to Default Settings:
When connected to your unit’s GPS receiver: Tapping the Return to
Default Settings button, the following settings are changed and
applied to your unit’s GPS
receiver:
• Resets NMEA strings to
defaults of:
o GGA – 1 sec
o GSA – 1 sec
o GLL – off
o VTG –
1 sec
o GSV – 1 sec
o RMC –
1 sec
NOTE: The COM settings are grayed out and cannot be changed until
you disconnect from your unit’s GPS receiver.
When disconnected from your unit’s GPS receiver: Tapping the
Return to Default Settings button, the following settings are changed:
• Resets NMEA strings to defaults of:
o GGA – 1 sec
o GSA – 1 sec
o GLL – off
o VTG –
1 sec
o GSV – 1 sec
o RMC –
1 sec
NMEA message settings (set to default or otherwise) will be sent to
your unit’s GPS receiver and applied the next time you connect to your
unit’s GPS receiver (with output set to NMEA).
• If the Microsoft GPS driver is not used, the COM port gets set to
COM2.
• If the Microsoft GPS driver is used, the COM port gets changed
to its assigned program port.
• Sets baud rate to 9600
• Data bits are set to 8
• Flow is set to None
• Parity is set to None
• Stop bit is set to 1