Product Manual
Table Of Contents
- Safety Information
- Introduction
- Getting Started
- Set up
- Setup
- Starting the Instrument
- Leveling
- Instrument Setup
- The Laser Pointer
- Measuring the Instrument Height
- Adjusting the Optical Plummet
- Pre Measurement Check List
- Connecting a Data Collector
- Instrument Technology
- Care & Maintenance
- Appendix
60
Connecting a Data
Collector
To perform surveying with the instrument a data collector
must be connected to the instrument running a field software.
Connect with Long Range Radio
The FOCUS 50 long range robotic model includes a long range
radio (LRR). To connect to a Spectra Geospatial data collector,
the channel and ID must match in both the instrument and the
Spectra Geospatial data collector.
The LRR is not available on Autolock or Short Range Robotic
models.
Connect with Bluetooth Wireless Technology
When Bluetooth wireless technology is used to connect to a
Spectra Geospatial data collector, the instrument serial
number appears as a device in the Spectra Geospatial data
collector with the serial number as ID. Select the device to
connect to the Spectra Geospatial data collector.
Note - Bluetooth wireless technology is not available on the
Autolock model.
Connect with cable
When a cable is used to connect to a Spectra Geospatial data
collector, it is automatically selected as the primary
communication. If the cable is disconnected, the instrument
will start to search for the Spectra Geospatial data collector
using LRR or Bluetooth wireless technology.
Note - Use only a communication cable approved by
Spectra Geospatial.