Product Manual
Table Of Contents
- Safety Information
- Introduction
- Getting Started
- Set up
- Setup
- Starting the Instrument
- Leveling
- Instrument Setup
- The Laser Pointer
- Measuring the Instrument Height
- Adjusting the Optical Plummet
- Pre Measurement Check List
- Connecting a Data Collector
- Instrument Technology
- Care & Maintenance
- Appendix
59
Pre Measurement
Check List
Before you begin measurement operations, check the
following items:
• Lenses are clean
• Instrument is correctly leveled
• Collimation error
• Tracker collimation error
• Trunnion axis tilt
• Correct radio channel is selected (Long Range Robotic
Model only)
• Laser Pointer beam alignment
• Measure instrument height
• Allow sufficient time for the instrument to adjust to the
ambient temperature, see page 22
Optical plummet
Ground mark
reticule 4x Adjustment screws