Product Manual

English

7. Put the battery door back into place by first inserting the

two lugs located at the bottom of the door (opposite the

lock).

8. Then push the battery door against the unit and lock it.

Turning On the

SP20

• Press the Power button [12] (see page 3) for a few

seconds until the SP20 vibrates, then release the button.

• Depending on how long your product was stored in its

package before being shipped to you, the remaining power

in the battery may be too low to allow the SP20 to operate

for your first working session. For this reason, the first

thing to do is to check the battery charge status:

– After the SP20 has started, read the battery icon in the

Android notification bar at the top of the screen. The

percentage of remaining charge is reported:

– If the remaining power is greater than 70%, then the

SP20 can be used for your first job. If it is less, Spectra

Precision recommends you first charge the battery as

explained below before you go to the field.