Product Manual

operate the receiver as a rover, the receiver will assume this

antenna model is still used in the rover configuration.

Raw Data

Recording

On the receiver’s General Status screen, the following icons

will appear in succession at a rate of 1 second when the

receiver is actually collecting raw data:

Using the Web Server

Using the Web Server to launch data recording is particularly

suitable for remote-controlled, static raw data collection.

• Go to Receiver > Memory.

• Enable Data Recording.

• Enter a site name for the location occupied by the

receiver.

• Choose the memory where to save the raw data file to.

• Choose a recording interval in Hz. Additionally, you may

ask the receiver to record the “TTT” message resulting

from the advent of any incoming external event and/or the

“PTT” message providing the time-tagging of the PPS

signal.

• Click Configure. The receiver starts recording the default

messages programmed on port M (as listed after Data

type). To change the content of this message, refer to Raw

Data Recording on page 76).

In the right part of the Memory tab screen, at the bottom

of the list of files stored in the selected memory, you can

now see – shown in red – the name of the file being

created.

Working from the Receiver Front Panel

Working from the receiver front panel to launch data

recording allows a rover operator to choose between “Static”

or “Stop & Go” data collection. A USB key connected to the

GNSS Raw Data

Acquisition