Product Manual

• Then you should indicate how the WiFi device will be

power-controlled and whether it will operate as a WiFi

client, as WiFi access point or both. Follow the steps

below:

– The previous screen being still displayed, press OK.

– Select Settings:

–Press OK again.

– Choose a power mode for the WiFi device: press OK,

select either Manual or Automatic (see explanations on

page 34 before making a choice) and then press OK.

– Press any of the vertical keys and then press OK.

– Choose an operating mode for the WiFi device: select

either Client, Access Point or Client and AP (depending on

the use case (see the next three sections below) and

then press OK.

– On your laptop or smart phone, start searching for WiFi

devices. When you have found your SP90m receiver,

select it and then enter the WiFi key (by default the

receiver serial number) to allow a WiFi connection with

the receiver

– Back on receiver side, press to go back to the WiFi

root screen. If you have selected Access Point or Client

and AP, you will be able to read the IP address of the

WiFi access point in the lower line. Type in this IP

address (fixed, static address: 192.168.130.1) in your

computer or smart phone’s web browser to launch the

receiver’s Web Server.

When a WiFi connection is active, one or two of the

following icons appear on the General Status screen:

The first one indicates that the WiFi device is used as

an access point and the second one as a client.