Product Manual

36
Pressing the down-arrow button will allow you to set the
following parameters:
1. Unit: Choose the distance unit (meters, US Survey Feet,
International Feet).
2. Screen Orientation: Choose the orientation of the data
displayed on the screen (Normal or Upside down).
3. Screen timeout: Choose the time in minutes during which
the screen will stay lit after you leave the control panel
inactive. It will go blank after this delay. You will then
need to press any key to turn it back on.
Choose “0000” to keep the screen permanently on.
4. Buzzer: Allows you to keep the buzzer silent (OFF)
whatever the events that would normally trigger it. The
buzzer is active (ON) by default.
Advanced Settings This screen looks like this:
Pressing the down-arrow button will allow you to set the
following parameters:
1. ATL Recording: Is OFF by default. ATL data are used for
advanced diagnosis. You don’t normally have to record
ATL data unless you are requested to do so by Technical
Support.
When you activate ATL recording (ON), the screen looks
like this:
Then make a long press on Escape to return to the General
Status screen so you can freely use the other screen
functions.
To stop ATL recording, go back to the ATL Recording
screen and press OK. Press OK again as a positive answer
to the message “Stop ATL?”. ATL recording stops right
away.
2. Reset Configuration?: This option allows you to reset the
receiver. You need to confirm this request before the reset
actually takes place.