Product Manual
installation if this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on. The user is encouraged to
try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
Changes and modifications not expressly approved by the
manufacturer or registrant of this equipment can void your
authority to operate this equipment under Federal
Communications Commission rules.
The radios in this device have been designed and
manufactured to not exceed stipulated emission limits for
exposure to radio frequency (RF) energy as required by the
Federal Communications Commission of the U.S.
Government 47 C.F.R. § 2.1091 and 2.1093. The external
antenna connector provided in this device is for GNSS
antennas only.
IC
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may
cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-
003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
This Category II radio communication device complies with
Industry Canada Standard RSS-310.
Ce dispositif de radiocommunication de catégorie II respecte
la norme CNR-310 d’Industrie Canada.
IMPORTANT NOTE:
IC Radiation Exposure Statement
This EUT is compliant with SAR for general
population/uncontrolled exposure limits in IC RSS-102 and
had been tested in accordance with the measurement
methods and procedures specified in IEEE 1528. This
equipment should be installed and operated with minimum
distance 0.5 cm between the radiator & your body.
This device and its antenna(s) must not be co-located or
operating in conjunction with any other antenna or
transmitter. The County Code Selection feature is disabled
for products marketed in the US/Canada.
CE
a. Caution:
• Risk of explosion if battery replaced by an incorrect type.
• Dispose of used batteries according to the instructions.
b. Make sure the temperature for adapter will not be higher
than 40 ˚C.
CE SARCompliance
This device meets the EU requirements (1999/519/EC) on
the limitation of exposure of the general public to
electromagnetic fields by way of health protection.
The limits are part of extensive recommendations for the
protection of the general public. These recommendations
have been developed and checked by independent scientific
organizations through regular and thorough evaluations of
scientific studies. The unit of measurement for the European
Council's recommended limit for mobile devices is the
"Specific Absorption Rate" (SAR), and the SAR limit is 2.0 W/ kg
averaged over 10 gram of body tissue. It meets the
requirements of the International Commission on Non-
Ionizing Radiation Protection (ICNIRP).
For body worn operation, this device has been tested and
meets the ICNIRP exposure guidelines and the European
Standard EN 50360, EN 50566, EN 62209-1 and EN 62209-2,
for use with dedicated accessories. Use of other accessories
which contain metals may not ensure compliance with ICNIRP
exposure guidelines.
RoHS Statement
This device conforms to RoHS (Reduction Of
Hazardous Sub-stances) European Union
regulations that set maximum concentration
limits on hazardous materials used in
electrical and electronic equipment.
CAUTION: RISK OF EXPLOSION IF BATTERY IS DISPOSED OF
INCORRECTLY. DISPOSE OF THE DEVICE AND THE BATTERY
ACCORDING TO INSTRUCTIONS FOR ELECTRONIC WASTE.
Canada
This Class B digital apparatus complies with Canadian ICES-
003.
Cet appareil numérique de classe B est conforme à la norme
NMB-003.
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including
interference that may cause undesired operation of the
device.
Spectra Precision MobileMapper 50 HandheldUser Guide | 4