Product Manual

English

Using Anti-Theft

and Startup

Protections in

FAST Survey

• Power on the SP60. Wait until the boot sequence is over.

• On the data collector, launch FAST Survey and open a job.

• Tap Equip to access the equipment menu.

• Tap on GPS Base or GPS Rover. Through the four tabs

presented, configure your SP60 as desired.

REMINDER: Anti-Theft protection only makes sense for a

base.

• Tap to complete the receiver configuration.

• Still from the Equip menu, tap on the GPS Utilities button.

This opens a menu now including the Theft Protection

button (this button is added to the menu following the

selection of the SP60 as the type of receiver used).

• Tap on the Theft Protection button. This opens a new

window showing the following parameters:

– Enable Startup Protection button: Allows you to activate

the startup protection after you have entered the

correct password, as defined below.

– Enable Anti-Theft button: Allows you to activate the anti-

theft protection after you have entered the correct

password, as defined below.

– Password button: Is used to define the password

needed to activate/deactivate the anti-theft and

startup protections.

Once one of the two protections has been activated,

you can no longer change the password.