Product Manual

English

Installing the UHF

Module into the

Receiver

• Power off the SP60 and turn it upside down.

• Use the L-shaped Torx screwdriver provided in the SP60

UHF kit to loosen and remove the four screws ([1])

securing the 5/8” threaded insert plate.

• Insert a finger into the 5/8” threaded hole ([2]), then

gently pull the plate out of the receiver, making sure you

free the ribbon cable anchored to the plate without

damaging it ([3]).

• Put away the 5/8” threaded insert plate in a safe place,

possibly for subsequent use.

• Take a look at the instructions printed on the label located

in the bottom of the recess.

• Connect the end of the ribbon cable (a 12-contact flat

connector) to the UHF module ([4]) as instructed on the

label (point 1).

• Insert the UHF module into the recess ([5]) as instructed

on the label (point 2).

• Re-use the four screws and Torx screwdriver to secure the

UHF module onto the receiver. Tighten the screws to

preserve receiver watertightness (torque meter: 3 N.m).

IMPORTANT: After installing (or removing) the internal

radio, you must reset the receiver (through hard reset or

via field software).

NOTE: The insertion of the UHF module DOES NOT modify

the ARP (Antenna Reference Point) of the GNSS antenna.

[3]

[1]

[2]

[4]

[5]