Product Manual

English

Configuring SP60

NOTICE: It is assumed you have a good knowledge of the field

software you are using. This section will only focus on the key

settings for implementing each of the available SP60

operating modes as rover or base. Remember other settings

may be required as you go along.

For more general information on the field software used,

please refer to the corresponding documentation.

With Survey Pro • Power on the SP60. Wait until the boot sequence is over.

• On the data collector, launch Survey Pro and open a job.

• Select Switch to GNSS to choose the GNSS survey mode.

•Using the Spectra Auto-Configure function, connect Survey

Pro to your SP60 via Bluetooth.

• Create the suitable receiver profile for your SP60:

*: On rover side, the data collector should first be connected to the same

Central account as the local base delivering corrections; Then select the

network named “Central Cloud Corrections” to acquire these corrections.

• Go back to Manage Instruments and select the receiver

profile you have just created.

SP60 Used As: Required Receiver Profile:

Network Rover “Net” (e.g. “SP60 0015 Net”)

L-Band Rover (RTX) “RTX” (e.g. “SP60 0015” RTX”)

SP60 Base/Rover

System Uses:

Receiver

Function

Required Receiver Profile :

1) Long-range Blue-

tooth, or

2) Radio link

Base “Base” (e.g. “SP60 0015 Base”)

Rover “Rover” (e.g. “SP60 0015 Rover)

Central*

Base

“Net Base” (typically a GNSS receiver

with built-in GPRS modem, e.g. SP80)

Rover “Net” (e.g. “SP60 0015 Net”)