User Guide

29
4-4. Setup – DEVICE Mode
In the SETUP menu, select the DEVICE tab. Then, the device menu is displayed as pictured below.
Navigate through the menu items or change the settings using the mouse or the remote control.
Figure 4.4.1. DEVICE Setup Screen
Table 4.4.1. Menu Items in DEVICE Setup Screen
Item
Description
ALARM OUT/
BEEP DURATION
Set the sensor, motion, and video loss for triggering alarm relay
HDD Error and Video Loss can trigger beeping
.
DIGITAL DETERRENT
Setup schedule and audio recordings for Digital Deterrent.
CONTROLLER & PTZ
Set the PTZ baud rate, protocol, and ID.
SPOT-OUT
CVBS OUT is can be used as Composite Video Output or Spot-Out
depending on the VIDEO OUTPUT resolution.
CVBS – Composite Video Output
SPOT – Spot-Out.
SITE
Select specified channel for motion zone setup.
MOTION ZONE
Select either Full Zone or Partial Zone for motion detection.
MOTION SENSITIVITY
Set the motion sensitivity for the selected channel.
Control the motion sensitivity from 1 to 9.