User Manual
27
O4P4/O4B6/O4B7M/O4D6/O4D7M/O4T7/O4T7M
The recommended information
Model
Surveillance Width
Focal-Length
Optimal Object
Distance
Installation Height
Depression Angle
O4P4/ O4B6/ O4D6/
O4T7
3.2m（10.5ft）
3.6mm
1.9m(6.2ft)
1.8m(5.9ft)
10°
O4B7M/O4D7M
/O4T7M/
3.2m（10.5ft）
2.8-12mm(W)
1.5m(4.9ft)
1.8m(5.9ft)
10°
2.8-12mm(T)
6.1 m(20ft)
2.6m(8.5ft)
10°
4. The object distancedepends on the focal-length of the lens mounted in the camera.
5. In order to guarantee the captured face recognition rate, the requirement for face capture are: left or right face turn angle is less
than about 30°; pitching angle is less than 20°.
6. Face illumination must be uniform, if the brightness is low or there is a large area of shadow, need to do the light filling.
7. When the capture scenario is backlight, the camera’s BLC/HLC/WDR need to be turned on, or fill the light.
8. The face recognition do not support black & white mode for now.
4.5 Network Configuration
4.5.1 TCP/IP
Go to NetworkTCP/IP interface as shown below. There are two ways for network connection.
Use IP address (take IPv4 for example)-obtain a local IP address automatically through DHCP. A typical router has a DHCP server
built in, and therefore is able to assign an IP address to the camera.
Use PPPoE-Click the “PPPoEConfig” tab to go to the interface as shown below. Enable PPPoE and then enter the user name and
password from your ISP.