User Manual

33
3. Set alarm trigger options. Trigger alarm out, Email and FTP. The setup steps are the same
as temperature screening settings. Please refer to temperature screening settings chapter for
details.
6.3.4 IP Address Conflict
1. Go to ConfigAlarmAnomalyIP Address Collision as shown below.
2. Click “Enable alarm” and set the alarm holding time.
3. Trigger alarm out. When the IP address of the camera is in conflict with the IP address of
other devices, the system will trigger the alarm out.
6.3.5 Cable Disconnection
1. Go to ConfigAlarmAnomalyCable Disconnected as shown below.
2. Click “Enable” and set the alarm holding time.
3. Trigger alarm out. When the camera is disconnected, the system will trigger the alarm out.
6.3.6 Alarm In
To set sensor alarm (alarm in):
Go to ConfigAlarmAlarm In interface as shown below.
Temperature Reading Panel with Face and Mask Recognition