User Manual

20
reader is connected to the Wiegand interface, please select “Wiegand Input”. If the access
controller is connected to the Wiegand interface, please select “Wiegand Output”.
You can also select the alarm output as needed.
5.3 Tampering Alarm Settings
In order to avoid the removal or damage by the external force, the tampering alarm can be set
for the terminal. Click ConfigAccess ControlTampering Alarm Setting to go to the
following interface.
Enable “Tampering Alarm” and then set the alarm holding time and alarm trigger options. The
setup steps of the alarm trigger options are the same as temperature Reading settings.
Please refer to temperature screening settings chapter for details.
Temperature Reading Panel with Face and Mask Recognition