User Manual

Temperature Reading & Face Recognition Terminal User Manual

5. Access Control Settings

5.1 Door Lock Settings

Click ConfigAccess ControlDoor Lock to go to the following interface. After the access

control device is connected to the terminal, you can set opening mode in this interface.

Opening Mode: Opening the door by face recognition or by password can be selected.

Delay Time of Opening the Door: Set how long the door will be opened after successful face

recognition or entering the correct password. The time range is from 0 to 10 seconds. For

example, “By Password” is selected and the delay time is set to “2” seconds; the door will be

opened 2 seconds later after entering the correct password.

Opening Duration: Set the opening duration after successful face recognition or entering the

correct password. The time range is from 0 to 10 seconds. For example, “By Password” is

selected and the delay time is set to “3” seconds; after the door is opened, it will be closed 3

seconds later.

5.2 Wiegand Settings

Click ConfigAccess ControlWiegand Config to go to the following interface.

Alarm Trigger Mode: Wiegand Input, Wiegand Output or Off can be selected. If the card