User Manual

9
Temperature Reading & Face Recognition Terminal User Manual
3. Temperature Reading
& Face Recognition Settings
3.1 Temperature Reading Settings
After the network is connected, go to the web client. Click Config
Temperature Screemomg to go to the following interface.
1. Enable Temperature Screening and then set the high temperature threshold and the
low temperature threshold. When the body temperature measured is higher or lower than the
set value, it will trigger alarms.
2. Set the alarm holding time.
3. Set the alarm trigger options.
Trigger Alarm Out: If enabled, the alarm output device will be triggered when detecting
abnormal temperature.
Trigger Audio Alarm: If enabled, the system will broadcast the current body temperature on
detecting a body. If the detected body temperature is normal, “Normal Temperature” will be
heard. If the detected body temperature is abnormal,
High/Low Temperature will be
heard. If this item is disabled, the detected temperature will be not broadcasted.
Trigger SD Snap: If enabled, the system will capture images on detecting abnormal