Manual

U
U
s
s
e
e
r
r
’
’
s
s
G
G
u
u
i
i
d
d
e
e
4.2. Quick Installation Guide
4.2.1. Connect PC and camera
to network.
1.
Prepare a PC to run programs for the installation and video connection
(PC is needed to assign IP address to
2.
In the case of using PoE, connect the PC and
your LAN Switch does not support standard PoE, connect
Figure
. The DC power is applied through DC adapter.
Figure 4
4.2.2. Set IP parameters
Follow the sequence below for setting the IP parameter
i) Run ONSIP installer
ii) Click
(1) in ONSIP installer window.
the parameters in (6)
iii) Click on
(9) to apply the settings.
iv)
You can connect to admin page by clicking on (10).
to network.
Prepare a PC to run programs for the installation and video connection
(PC is needed to assign IP address to
camera)
In the case of using PoE, connect the PC and
camera
to the network using one of the following ways. If
your LAN Switch does not support standard PoE, connect
the main unit as
shown in dotted line in
. The DC power is applied through DC adapter.
Figure 4
-1. Power and network connection
Follow the sequence below for setting the IP parameter
(1) in ONSIP installer window.
> Double click on (2) > Fill in (4) > make a selection in (5) > Fill
(9) to apply the settings.
You can connect to admin page by clicking on (10).
LAN switch with
standard POE
(802.3af)
LAN switch
DC adaptor
to the network using one of the following ways. If
shown in dotted line in
> Double click on (2) > Fill in (4) > make a selection in (5) > Fill