User Manual

23
the alarm list.
Alarm list: Select a list as the comparison list. Allow list, block list or unknown vehicle can be optional.
Alarm out: if enabled, the system will trigger alarm output when the captured license plate is matched successfully.
After all above information are set, go to the live interface and click to see the captured pictures as shown below.
When the captured license plate is matched with the license plate of the comparison list, the list type will be displayed under the license plate number.
Click the matched license plate picture, the matched details will pop up as shown below.
※ Configuration requirements of camera and surrounding area
Note: The following installation requirements are based on optimum conditions, your license capture rate may vary depending on speed, lighting,
position, license plate designs and other factors.
 The monitoring image shall try to cover the lane, entering/exiting vehicles and these vehicles’ plate number shall be always seen in the video.
 Try to avoid the objects that will block the camera, such as pillars, obstacles, doors, etc.
 Avoid the scenes with many trees or other moving objects (like humans, non-motor vehicles).
Overhead monitoring:
 The installation height (H) shall range from 15 ~ 20ft.
 The distance D (between the location of the camera installation and the captured area) shall range from 50 ~ 82ft. This distance (D) depends on the
installation height, usually 3 or 4 times as far as the installation height (H).
 The distance of the captured area (L) shall be from 50 ~ 65ft.
 The speed of the vehicles shall not exceed 40mph.