User Manual

22
 Add vehicles
Click “Add” to show a vehicle adding box as shown in the above figure. Enter the license plate number, select list type, start and end time, enter owner
and license plate type. Then click “Save” to save the vehicle.
List type: unknown vehicle, allow list and block list can be selected.
Click “Bulk Entry” to add multiple vehicles at one time as shown below.
Please edit the vehicle information according to the requirements shown on the above interface. If you don’t know how to edit the file, please click
“Download” to download an example file and then follow the example to edit. After that, click “Browse” to choose the vehicle information file and click
“Upload” to import all vehicle information.
 Search vehicles
After the vehicles are added, you can search them in the vehicle list. Enter the license plate number and list type and then click “Search” to search the
added vehicle information. Click “Modify” to modify its information. Click “Delete” to delete this vehicle information.
7. Set the license plate comparison and alarm linkage. Click the “Comparison and linkage” tab to go to the following interface.
Set the fault tolerance, alarm list and check “alarm out”. Finally, click “Save” to save all the settings.
Allow fault character(s) of the plate number: up to 2 characters are allowed. For example, if “2” is selected, the captured license plate will be matched
successfully and trigger the corresponding alarm even if there are 2 characters (or less) of the captured license plate not matched with the license plate of