User Manual

17
2. Click “Enable” and set the alarm holding time.
3. Set alarm trigger options. Trigger alarm out, Email and FTP. The setup steps are the same as motion detection. Please refer to
motion detection chapter for details.
 IP Address Conflict
This function is only available for the models with Alarm Out interface.
1. Go to Alarm AnomalyIP Address Collision as shown below.
2. Click “Enable alarm” and set the alarm holding time.
3. Trigger alarm out. When the IP address of the camera is in conflict with the IP address of other devices, the system will trigger the
alarm out.
 Cable Disconnection
This function is only available for the models with Alarm Out interface.
1. Go to Alarm AnomalyCable Disconnected as shown below.
2. Click “Enable” and set the alarm holding time.
3. Trigger alarm out. When the camera is disconnected, the system will trigger the alarm out.