Quick Start Guide O2BLP1M
1 Warning and Caution 2 Package
Camera Quick start guide CD Drill template Screwdriver Junction box 4 tapping screws 1 machine screw Plastic plug ×4 Overview 33 Overview 1 1 4 5 432 ALA RM 2 3 6 7 8 9 10 1 Ethernet Connector 2 MIC-Audio Input 3 HP-Audio Output 4 Alarm Output/Input 5 Power Connector * 6 Micro SD Card Slot 7 Zoom +* 8 Zoom -* 9 CVBS output (unavailable) 10 Reset * 1 It is recommended to install the security cap for outdoor installation.
p ca y rit cu Se ALAR 4321 M 1--ALM-COM 2--ALM-OPEN 3--ALM-INA 4--ALM-GND DC12V * 1 It is recommended to install the security cap for outdoor installations. * 2 DC 12V power supply is not required if a PoE switch or injector is used to power the camera. ► Connecting Network Cable 1 2 3 ① Loosen the nut from the main element. ② Run the network cable (without RJ 45 connector) through both elements. Then crimp the cable with RJ 45 connector. ③ Connect the cable to the hermetic connector.
4 Installation SD Card Installation Open the cover of the camera as shown in the following figure and then insert a micro SD card. After that, install the cover back to the camera (Note that the cover shouldn’t be installed unevenly). Insert a micro SD card Cover Camera Installation with a Junction Box * Before you start, please make sure that the wall or ceiling is strong enough to withstand three times the weight of the camera and junction box.
③ Fix the mounting base of the camera to the upper cover of the junction box. ④ Route the cables through the cable hole and connect the camera. Then install the camera onto the mounting base of the junction box. ⑤ Three-axis Adjustment-Before adjustment, preview the image of the camera on a monitor and then loosen the fixed screws to adjust the camera according to the figure below to get an optimum angle.
Fixed screws Pan 360° Tilt 90° Rotate 360° Configuration requirements of camera and surrounding area Note: The following installation requirements are based on optimum conditions, your license capture rate may vary depending on speed, lighting, position, license plate designs and other factors. The monitoring image shall try to cover the lane, entering/exiting vehicles and these vehicles' plate number shall be always seen in the video.
H 15~20feet <40MPH L 50~65 feet D 50~82 feet The depression angle of the camera shall range from 10° to 15°. If the camera is installed on the side of the road, the pan angle of the camera shall range from 0° to 20°. If the camera is installed right above the middle of the road, the pan angle of the camera shall range from -10° to 10°. Entrance & Exit Monitoring The installation height (H) shall range from 4.2ft to 5ft.
The depression angle of the camera shall range from 0° to 5°. The pan angle of the camera shall range from 5° to 20°. The tilt angle of the license plate After the camera is installed, you can log in the web client and view whether the license plate tilts in the video. The tilt angle shall range from -5° to 5°. If the captured license plate doesn't meet the above requirement, you can adjust the pan angle of the camera to correct it.
O2BLP1M 192.168.17.251 5 C:F2:07: 2 4:68:9A n/a n/a ③ In the device list, you can view the IP address, model number, and MAC address of each device. Select the applicable device and double click to open up the web viewer. You can also manually enter the IP address in the address bar of the web browser. The login interface is shown above. Default user name is admin and password is 1234. After logging in, follow directions to install applicable plugins.
