User Manual

51
Specification /Model
O2DFRM
Camera
Image Sensor
1/2.8CMOS
Image Size
1920×1080
Electronic Shutter
1/25s~1/100000s
Iris Type
Fixed Iris
Min. llumination
0 lux
Lens
7~22mm@F1.4, horizontal FoV:37°~22.5°, recommended face capturing distance: 5~15m
Lens Mount
Ø 14
Day&Night
ICR
WDR
Digital WDR
Digital NR
3D DNR
Angle Adjustment
Pan: 0°~345°; Tilt 0°~77°; Rotation:0°~345°
Image
Video Compression
H.265+/H.265/H.264+/H.264/MJPEG
H.264 Type
Baseline profile/main profile/high profile
Video Bit Rate
128Kbps~6Mbps
Resolution
1080P, 720P, D1, CIF, 480×240
Main Stream
60Hz: 1920×1080/1280×720(1~30fps); 50Hz: 1920×1080/ 1280×720(1~25fps)
Sub Stream
60Hz: D1/CIF(1~30fps); 50Hz: D1/CIF (1~25fps)
Third Stream
60Hz: CIF/ 480×240 (1~30fps); 50Hz: DCIF/ 480×240 (1~25fps)
Image Settings
BLC, HLC, Defog, Saturation, Brightness, Chroma, Contrast, Wide Dynamic, Sharpen, NR, etc.
adjustable through client or web browser
ROI
Supported
Interfaces
Network
RJ45
Auido
MIC IN×1, Line OUT×1
Video
BNC×1 (analog output)
RS485
Terminal block
Storage
Built-in micro SD card storage slot, up to 128 GB
Alarm
1CH alarm input; 1CH alarm ouput (terminal block)
Fucntion
Remote Monitoring
Web browser, CMS remote control
Online Connection
Support simultaneous monitoring for up to 6 users and multi-stream transmission
Network Protocol
IPv4, IPv6, UDP, DHCP, NTP, RTSP, PPPoE, DDNS, SMTP, FTP, SNMP, HTTPS, 802.1x, QoS
Interface Protocol
ONVIF, GB-T/28181-2011
Storage
Network remote storage, micro SD card storage
Smart Alarm
Motion detection, Sensor detection, SD card Full, SD card error, IP conflict, cable disconnection,
face detection
Protection Grade
IP67&IK10
Power
AC24V/DC12V/PoE
Power Consumption
< 4W
Opterating
Environment
Temperature: -22°F~140°F; Relative Humidity: less than 95% (non-condensing)
Dimension (mm)
5.56 )×3.94(H)
Weightnet
Approx. 1.96lbs
Installation
Ceiling mounting (Wall mounting available with the junction box and bracket)
Models: O2BFR/O2BFRM/O2DFR/O2DFRM
Federal Communications Commission (FCC) Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Responsible Party:
Speco Technologies
200 New Highway
Amityville, NY11701
www.specotech.com