User Manual

24
5. Set the schedule of the crowd density detection. The setup steps of the schedule are the same as schedule recording setup (See
Schedule Recording).
※Configuration of camera and surrounding area
1. The camera lens should face to the people flow. The direction of the people flow is allowed to deviate slightly from the direction
of the camera lens (The angle (a) shall be less than 45°). It is recommended that the angle (b) shall range from 30° to 60°.
2. The size range of a single person image should occupy from 1% to 5% of the entire image and the height range of a single person
image should occupy from 1/5 to 1/2 of the entire image.
3. This function is inapplicable to the scene where there are many moving objects except human shape. (eg. moving cars)
4. A lot of trees and billboards will affect the detection results in the detected area.
4.4.6 People Intrusion
This function is specially designed for indoor scenes. To prevent someone from intruding a house to endanger the family security,
you can enable this function. Alarms will be triggered if someone enters into the detection area in 3~5s. The setup steps are as
follows.
1. Go to AnalyticsPeople Intrusion. Please refer to the following picture.
2. Enable the people intrusion detection.
3. Set “Alarm Sensitivity” and “Alarm Holding Time”.
4. Set alarm trigger options. The setup steps are the same as motion detection setup. Please refer to motion detection chapter
for details.
5. Set the schedule of the people intrusion detection. The setup steps of the schedule are the same as schedule recording setup
(See Schedule Recording).