User Manual

18
Alarm Out Mode: Alarm linkage, manual operation, day/night switch linkage and schedule are optional.
Alarm Linkage: Having selected this mode, select alarm out name and alarm holding time at the “Alarm Holding Time” pull down list
box.
Manual Operation: Having selected this mode, click “Open” to trigger the alarm out immediately; click “Close” to stop alarm.
Day/Night Switch Linkage: Having selected this mode, choose to open or close alarm out when the camera switches to day mode or
night mode.
Timing: Click “Add” and drag the mouse on the timeline to set the schedule of alarm out; click “Erase” and drag the mouse on the
timeline to erase the set time schedule. After this schedule is saved, the alarm out will be triggered in the specified time.
4.3.5 Alarm Server
Go to AlarmAlarm Server interface as shown below.
Set the server address, port, heartbeat and heartbeat interval. When an alarm occurs, the camera will transfer the alarm event to
the alarm server. If an alarm server is not needed, there is no need to configure this section.
4.4 Analytics Configuration
This series of IP cameras supports certain smart functions, such as object removal, line crossing detection, region intrusion detection,
etc. These events can be triggered as alarm events.
For more accuracy, here are some recommendations for installation.
 Cameras should be installed on stable surfaces, as vibrations can affect the accuracy of detection.
 Avoid pointing the camera at the reflective surfaces (like shiny floors, mirrors, glass, lake surfaces and so on).
 Avoid places that are narrow or have too much shadowing.
 Avoid scenario where the object’s color is similar to the background color.
 At any time of day or night, please make sure the image of the camera is clear and with adequate and even light, avoiding
overexposure or too much darkness on both sides.