User Manual

Record & Disk Management
NVR User Manual
38
 RAID Rebuilding
If one of your disks is broken, the disk indicator on the front panel will turn red. Of course, a warning tip will pop up if the relevant HDD exception
alarm is set. You need to rebuild the RAID after you replace the broken disk with a new one.
Click the above circled icon and then select the physical disk to rebuild.
7.4.2 Storage Mode Configuration
Click StartSettingsDiskStorage Mode to go to the interface as shown below.
By using disk group, you can correspond the camera to disk (the record data of the camera in the group will be stored into the disks in the same
group). The NVR with e-SATA interface supports e-SATA recording.
The added disks and cameras will be added into group one automatically. The disks and cameras in the groups can be deleted except group one
(select a disk group and then click on the top right corner of the added disk or camera to delete it from the group). The deleted disks and
cameras will be moved into group one automatically.