User Manual
Record & Disk Management
NVR User Manual
32
7 Record & Disk Management
7.1 Record Configuration
7.1.1 Mode Configuration
Please format the HDDs before recording (refer to 7.4 Disk Management for details). Click StartSettingsRecordMode Settings to go to the
mode settings interface. You can set the record time under the “Manual Record Settings” and then click “Apply” to save the settings. There are two
record modes: auto mode and manual mode.
Auto Mode
Motion Record: Motion alarm record will be enabled when motion alarm happens.
Sensor Record: Sensor alarm record will be enabled when sensor alarm happens.
Motion Record+Sensor Record: Motion/sensor alarm record will be enabled when motion/sensor alarm happens.
Continuous Record+Motion Record: Normal record is enabled all the time; motion alarm record will be started when motion alarm happens.
Continuous Record+Sensor Record: Normal record is enabled all the time; sensor alarm record will be started when sensor alarm happens.
Continuous Record+Motion Record+Sensor Record: Normal record is enabled all the time; motion/sensor alarm record will be enabled when
motion/sensor alarm happens.
Continuous Record+Motion Record+Sensor Record+ AI Record: Normal record is enabled all the time; motion/sensor/analytics alarm record will be
enabled when motion/sensor/intelligence analytics alarm happens.
You can add more auto modes on intelligence record. Click “Advanced” button to pop up a window as shown below. Check the modes in the window
and then click “Add” button to show the modes in the record mode list (in the window, the checked modes can be showed in the record mode list
while the unchecked modes cannot; you shall check “AI Record”).
Select one auto mode to pop up the corresponding window. Set the encode, GOP, resolution, FPS, bitrate type, quality, max bitrate and audio of each
camera and then click “OK” to save the settings. Please adjust the parameters according to the actual condition.