User Manual

Live View Introduction

NVR User Manual

5.2 View Mode

5.2.1 Display Mode

Set different screen modes and cameras’ display sequences as needed and then save the display modes classified by surveillance areas, priorities

and so on. Refer to the picture below. Double click one display mode in the display mode list to view the live images in this mode.

 Add Display Mode

Method One:

① Click “Customize Display Modes” in the above interface

② Click to add a display mode name and then set the screen mode.

③ Add the cameras and adjust the cameras’ display sequence as required.

④ Click under the display mode list.

Method Two:

① Click StartSettingsSystemBasicOutput Settings to go to the interface and then set the screen mode.

② Double click the camera or camera group in the list to add them to the selected window.

③ Click to save the current display mode (refer to 5.2.4 Scheme View in Sequence for detail configurations). The display mode will be saved

and displayed in the display mode list in the live preview interface.

 Edit Display Mode

Click “Customize Display Modes” tab in the live preview interface and then select one display mode in the list. Click to edit the display mode