Instruction Manual

3.13 Dome Setup

CONFIGURATION MENU

HOME FUNCTION SETUP

VIEW ANGLE SETUP

ORIGIN OFFSET

FACTORY DEFAULT

DOME RESET

OSD DISPLAY

SYSTEM SETUP

FUNCTION RUN

SYSTEM INFORMATION

EXIT(ESC TO EXIT)

• HOME FUNCTION SETUP

HOME FUNCTION SETUP

FUNCTION : NONE

NUMBER : ---

WAITING TIME : 120 SEC

ENABLE : OFF

SAVE AND EXIT(ESC TO CANCEL)

FUNCTION NONE, TOUR, PATTERN, AUTO SCAN, PRESET

NUMBER ---

WAITING TIME 10 ~ 240 seconds

ENABLE ON, OFF

The Home Function can be set so that the camera automatically goes to Tour, Pattern, Auto

Scan or Preset after the keyboard controller has been idle for a specified amount of time.

For example, if the controller is idle for 120 seconds, the camera goes to Preset 1.

Follow these steps to program the Home position:

1. Select “FUNCTION” by pushing the Joystick to the left or right to scroll through the None,

Tour, Pattern, Auto Scan or Preset functions.

2. Select “NUMBER” and push the Joystick to the left or right. The recorded function number

will scroll.

3. Select “WAITING TIME” and push the Joystick to the left or right to select from 10 to 240

seconds.

4. Select “ENABLE” and turn to ON or OFF by pushing the Joystick to the left or right.