Instruction Manual

12
NOTE: Open the DIP switch cover and change the setting of DIP switch.
The cover should be closed after setting DIP switch.
2.4 Setting Dome Camera Address (ID)
To prevent damage, each dome camera must have a unique address (ID).
The factory default setting is 1.
Refer to ‘3.11 Dome Communication’ section for detailed information.
2.5 Setting Dome Camera Video Signal & Coaxitron Protocol
S1
You can set video signal with D1 in S1.
S1-D1
Video Signal
OFF
HD-TVI OUTPUT
You can set coaxitron protocol with D2 and D3 in S1.
S1-D2
S1-D3
HD-TVI OUTPUT
ON
OFF
Speco-C