Installation Guide

Installation Guide
(1)
(2)
(3)
(4)
(5)
(6)
Connect all cable connectors,
make the water proof rubber go
through the tail of video and
power cables;
Put all cables into the junction box
body;
Use 3pcs PM4*8 machine screws
to fix the camera on the round
plate.
Use allen wrench to loosen
the screw on the bullet bracket
as picture shown;
Adjust the viewing angle you
need, then fasten the screw.
Noting: You can rotate 3
directions freely as picture
shown.
Drill Holes according to the
position drawing paper and plug
into the rubbers
Use 3pcs PWA4*25 self-tapping
screws to fix the junction box
body.
Paste the cotton pad on the
bottom of junction box, place the
water proof rubber ring on the
top of the junction box body.
Use 3pcs KM4*10 machine
Screws to fix the round plate on
the junction box body.
Waterproof
Rubber