Manualshelf

Manual

ManualsBrandsSpeco ManualsDome Security Cameras4MP HD-TVI FIT Dome Camera, 2.8-12mm Lens, Grey Housing with Junction Box
21222324252627282930
- 27 -
* BOX
ZONE NUM [0~15] : Select a mask out of the 16 mask areas and set the options below for the selected
mask.
ZONE DISP [ON, OFF] : Choose ON to activate privacy masks and press OFF to deactivate masks.
H-POS [0~60] : Define the horizontal start position of the privacy mask.
V-POS [0~34] : Define the vertical start position of the privacy mask.
H-SIZE [0~60] : Define the horizontal size of the privacy mask.
V-SIZE [0~34] : Define the vertical size of the privacy mask.
Y LEVEL [0~20] : Define the brightness of the mask color.
CB LEVEL [0~20] : Define the blue amount of the mask color.
CR LEVEL [0~20] : Define the red amount of the mask color.
TRANS [0~3] : Applies a tone from the window to act on the selected area.
* POLYGON
ZONE NUM [0~15] : Select a mask out of the 16 mask areas and set the options below for the selected
mask.
ZONE DISP [ON, OFF] : Choose ON to activate privacy masks and press OFF to deactivate masks.
POS0-X : You can select the horizontal & Diagonal starting position of the monitoring area.
POS0-Y : You can select the vertical & Diagonal starting position of the monitoring area.
POS1-X : You can select the horizontal & Diagonal starting position of the monitoring area.
POS1-Y : You can select the vertical & Diagonal starting position of the monitoring area.
POS2-X : You can select the horizontal & Diagonal starting position of the monitoring area.
POS2-Y : You can select the vertical & Diagonal starting position of the monitoring area.
POS3-X : You can select the horizontal & Diagonal starting position of the monitoring area.
POS3-Y : You can select the vertical & Diagonal starting position of the monitoring area.
Y LEVEL [0~20] : Define the brightness of the mask color.
CB LEVEL [0~20] : Define the blue amount of the mask color.
CR LEVEL [0~20] : Define the red amount of the mask color.
TRANS [0~3] : Applies a tone from the window to act on the selected area.
8. SYSTEM
This can be used when you want to select the additional function control.
1.When the SETUP menu is displayed, select SYSTEM using the Up and Down button.
2. Select one of the mode using the Up and Down button.
Speco(Fit).indd 27 2020-05-21 오전 9:52:26