H8D6M/H8B6M User Manual Thank you for purchasing our product. Speco Technologies is constantly developing and improving products. We reserve the right to modify product design and specifications without notice and without incurring any obligation.
Warnings ■ If the product does not work properly, please contact the dealer or where the product was purchased. Speco Technologies is not responsible for any problems caused by improper operation or repair. ■ Keep away from liquid while in use. ■ All installation and operation here should conform to local electrical safety codes. ■ Make sure the power supply voltage is correct before using the camera. ■ Do not drop the camera or subject it to physical shock.
● Backlight Compensation (BLC) When the back of the captured object is too much bright, you can set BLC for the captured object to make it clearer. Cables Video Output Video Switch Cable Power Cable Video Switch: Four video output modes can be optional--AHD, TVI, CVI and CVBS (a) remove the cover of the video switch cable; (b) hold and press the button in the video switch cable for 5 seconds to switch the current video output.
. Bracket adjustment. Before adjustment, preview the image of the camera on a monitor and then loosen the fixed ring to adjust the view angle of the camera. Tighten the fixed ring after the adjustment. Pan 360° Tilt 90° Fixed Ring ►Mounting for H8D6M 1. Loosen the screws to open the lower dome and then loosen the lock screw to remove the mounting base. 2.
3. Route and connect the cables. And then secure the mounting base to the ceiling or wall with the screws provided. Sponge Mounting Base 4. Fix the camera to the mounting base with the lock screw. 5. Three-axis adjustment. Before adjustment, preview the image of the camera on a monitor and then adjust the camera according to the figure below to get an optimum angle. 6. Install the lower dome back to the camera with the screws and remove the protection film softly to complete the installation.
Specifications Models H8D6M H8B6M Specifications Camera Image Sensor 1/2.5" CM O S Resolution 8MP Image size 3840×2160 Video Output AHD/TVI/CVI/CVBS (*camera comes defaulted to HD-TVI) Image System PAL/NTSC Electronic Shutter Auto; 1/50s~1/100000s(PAL);1/60s~1/100000s (NTSC) IR Distance (feet) 32.8~65.6 Frame Rate 15fps Min. Illumination Color:0.01lux@F1.2, AGC ON; B/W: 0lux with IR Lens 2.
Model: H8B6M/H8D6M Federal Communications Commission (FCC) Statements This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Responsible Party: Speco Technologies 200 New Highway Amityville, NY 11701 www.specotech.
