User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Device Management
DVR User Manual
75
11.2.3 Recorder OSD Settings
Click Start→Settings→System→Basic→Recorder OSD settings to go to the following interface. Name, icon
and address OSD can be enabled here.
11.3 Factory Default
Click Start→Settings→System→Maintenance→Factory Default and then click “Restore factory setting”
button in the interface to reset to the factory default settings (check “all except the network” to retain the
network settings). Click “Restore default parameter” to restore the parameters to the default status (check
“all except the network” to retain the network settings).
Note: Resetting to the factory default settings will not change time zone.
11.4 Device Software Upgrade
⚫ Upgrade
You can click Start→Settings→System→Information→Basic to view MCU, kernel version and firmware
version and so on. Before upgrade, please get the upgrade file from your dealer.
The upgrade steps are as follows:
① Copy the upgrade software into the USB storage device.
② Insert the USB storage device into the USB interface of the DVR.