User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Account & Permission Management
DVR User Manual
66
10.3.2 Edit Permission Group
Go to “Edit Permission Group” interface and then click in the group list to edit the permission group
(the operations of the “Edit Permission Group” are similar to that of the “Add Permission Group”, please see
10.3.1 Add Permission Group for details). Click to save the group as another group. Click to delete the
permission group. The three default permission groups (“Administrator”, “Advanced” and “Common”)
cannot be deleted.
10.4 Block and Allow List
① Click Start→Settings→Account and Authority→Security to go to the following interface.
② Check “Enable” and then choose “Enable Allow List” or “Enable Block List” (the PC client of which the IP
address is in the allow list can access DVR remotely while the PC client in the block list cannot).
③ Add IP/IP segment/MAC. Click “Add IP” or “Add MAC” button and then check “Enable” in the popup
window (only if you check it can the IP/IP segment/MAC you add be effective). Enter the IP/IP segment/MAC
and then click “OK” button. In the above interface, click to edit IP/IP segment/MAC, click to
delete it. Click “Apply” to save the settings.
10.5 Preview On Logout
Click Start→Settings→Account and Authority→Security→Preview on Logout to go to the following
interface.