User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Account & Permission Management
DVR User Manual
65
➢ Edit User
Click “Edit User” to pop up the window as shown below. The admin is enabled, its permission control is
closed and permission group cannot be changed by default. You can enable or disable other users (if
disabled, the user will be invalid), open or close their permission control (if closed, the user will get all the
permissions which admin has) and set their permission groups. Click “OK” to save the settings.
10.2 User Login & Logout
Login: Click Start→Login or directly click the preview interface and then select username and enter the
password in the popup window. Click “Login” button to log in the system.
Logout: Click Start→Logout or click Start→Shutdown to pop up the “Shutdown” window. Select “Logout” in
the window and then click “OK” button to log out the system.
10.3 Permission Management
10.3.1 Add Permission Group
Click Start→Settings→Account and Authority→Account→Edit Permission Group to go to the interface as
shown below.
Click to add permission group. Set the group name, check the permissions as needed and then set the
“Local” and “Remote” permissions. Click “Add” to save the settings.