User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Alarm Management
DVR User Manual
61
9.5.4 Buzzer
Click Start→Settings→Alarm→Event Notification→Buzzer to go to the buzzer configuration interface. Set
the delay time of the buzzer and then click “Apply” to save the setting. You can click “Test” to test the
buzzer.
9.5.5 Push Message
Click Start→Settings→Alarm→Event Notification→Push Message to go to the interface as shown below.
Check “Enable” and then click “Apply” button to save the settings. If Push Server is online, it will push
messages to the mobile clients.
9.5.6 Alarm Server
Go to Alarm→Alarm Server interface as shown below.
Enable the alarm server and enter server address and port of the alarm server. Then select protocol. If “Send
Heartbeat” is enabled, set the interval times. After that, test the effectiveness of the alarm server. Having
tested successfully, please click “Apply”. When an alarm occurs, the device will transfer the alarm event to
the alarm server. If an alarm server is not needed, there is no need to configure this section.