User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Alarm Management
DVR User Manual
60
② Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video”, “Pop-up
Message Box” and “E-mail”. The Video Loss Settings are similar to that of the sensor alarm (see9.1 Sensor Alarm
for details).
③ Click “Apply” to save the settings.
9.4.3 Warning Handling Settings
① Click Start→Settings→Alarm→Exception→Warning Handling Settings to go to the interface as shown
below.
② Enable or disable “Push”, “Alarm-out”, “Buzzer”, “Pop-up Message Box” and “E-mail”. The exception
handling settings are similar to that of the sensor alarm (see 9.1 Sensor Alarm for details).
③ Click “Apply” to save the settings.
9.5 Alarm Event Notification
9.5.1 Alarm-out
① Click Start→Settings→Alarm→Event Notification to go to the following interface.
② Set the delay time and the schedule of each alarm-out. You can click “Edit Schedules” to edit the
schedules (see 7.3.1 Add Schedule for details).
③ Click “Apply” to save the settings. You can click “Test” to test the alarm output.
9.5.2 E-mail
Click Start→Settings→Alarm→Event Notification→E-mail to go to the e-mail configuration interface. Set the
e-mail address of the recipients. See 11.1.5 E-mail Configuration for details.
9.5.3 Display
Click Start→Settings→Alarm→Event Notification→Display to go to the display configuration interface. Set
the duration time of the pop-up video and the pop-up message box. Click “Apply” to save the settings.