User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Alarm Management
DVR User Manual
58
② Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video” and “E-mail”. The
alarm handling setting of line crossing alarm is similar to that of the sensor alarm (see 9.1 Sensor Alarm for
details).
③ Click “Apply” to save the settings. You can click “Crossing Config” to go to the line crossing configuration
interface.
9.3.4 Intrusion Detection
Intrusion Configuration:
Alarms will be triggered if someone or something intrudes into the pre-defined area.
① Click Start→Settings→Camera→Intelligent Analytics→Intrusion Detection to go to the following interface.
② Select the camera, enable the intrusion detection.
③ Select the alarm area. Up to 4 alarm areas can be set up.
④ Draw the alarm area of the intrusion detection. Refer to the interface as shown below. Check “Draw Area”
and then click around the area where you want to set as the alarm area in the image (the alarm area should
be a closed area). Uncheck the “Draw Area” if you finish the drawing. Click the “Clear” to delete the alarm
area.
⑤ Click “Apply” to save the settings.
⑥ Click “Processing Mode” to go to the alarm handling configuration interface of intrusion detection.
Intrusion Detection Alarm Handling Configuration:
① Click Start→Settings→Alarm→Intelligence Alarm→Intrusion to go to the following interface.