User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Alarm Management
DVR User Manual
56
Object Detection Alarm Handling Configuration:
① Click Start→Settings→Alarm→Intelligence Alarm→Object Detection to go to the following interface.
② Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video” and “E-mail”. The
alarm handling setting of object detection alarm is similar to that of the sensor alarm (see 9.1 Sensor Alarm for
details).
③ Click “Apply” to save the settings. You can click “Object Config” to go to the object detection configuration
interface.
9.3.2 Tampering
Tampering Configuration:
① Click Start→Settings→Camera→Intelligent Analytics→Tampering to go to the following interface.
② Select the camera and enable the relevant detection as needed.
Scene Change: Alarms will be triggered if the scene of the monitor video has changed.
Video Blurred: Alarms will be triggered if the video becomes blurry.
Video Color Cast: Alarms will be triggered if the video becomes obscured.
③ Set the sensitivity of the exception detection.
④ Click “Apply” to save the settings.
⑤ Click “Processing Mode” to go to the alarm handling configuration interface of exception detection.