User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Alarm Management
DVR User Manual
55
9.2.2 Motion Alarm Handling Configuration
① Click Start→Settings→Alarm→Motion Alarm to go to the following interface.
② Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video” and “E-
mail”. The alarm handling settings of motion alarm the same as the sensor alarm (see 9.1 Sensor Alarm for
details).
③ Click “Apply” to save the settings. You can click “Motion Settings” to go to the motion configuration
interface.
9.3 Smart Event
9.3.1 Object Detection
Object Detection Configuration:
① Click Start→Settings→Camera→Intelligent Analytics→Object Detection to go to the following interface.
② Select the camera, enable the object detection and set the detect type. There are two detect types:
Abandoned object and missing object.
Abandoned object: Alarms will be triggered if there are articles left in the pre-defined detection area.
Missing object: Alarms will be triggered if there are articles missing in the detection area drawn by the users.
③ Select the alarm area. A maximum of 4 alarm areas can be set.
④ Draw the alarm area of the object detection. Refer to the interface as shown above. Check “Draw Area”
and then click around the area where you want to set as the alarm area in the image (the alarm area should
be a closed area). Uncheck the “Draw Area” if you finish the drawing. Click the “Clear” to delete the alarm
area.
⑤ Click “Apply” to save the settings.
⑥ Click “Processing Mode” to go to the alarm handling configuration interface of object detection.