User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Alarm Management
DVR User Manual
44
cameras in the window and then click “Add” to add playback camera. The system supports a maximum of 16
synchronous playback cameras.
The buttons on the tool bar (area ①) at the bottom of the playback interface are introduced in the table
below.
Button
Meaning
Start button. Click it to pop up area ②.
Full screen button. Click it to show full screen; click it again to exit the full screen.
Screen mode button.
OSD ON button. Click it to enable OSD; click it again to disable OSD.
Stop button.
Rewind button. Click it to play video backward.
Play button. Click it to play video forward.
Pause button.
Deceleration button. Click it to decrease the playing speed.
Acceleration button. Click it to increase the playing speed.
Previous frame button. It works only when the forward playing is paused in single screen
mode.
Next frame button. It works only when the forward playing is paused in single screen
mode.
Click to step backward 30s and click to step forward 30s.
Click it to show the water mark on the image; click to hide the water mark.
Event list/tag button. Click it to view the event record of manual/schedule/sensor/
motion and the tag information.
Backup button. Drag the mouse on the time scale to select the time periods and
cameras, and then click the button to back up the record.
Backup status button. Click it to view the backup status.
Back button. Click it to return.
Full screen motion button.
Motion button.
Draw line button. You can search the record of crossing the line after drawing the line.
Draw quadrilateral. You can search the record in this quadrilateral after drawing it.
Smart playback settings. Click it to set smart playback.
Introduction of area ②:
Button
Meaning
Click it to go to record search and export interface; see 8.4 Record Search,
Playback & Backup for details.
Click it to Go to the live view interface; see Chapter 5 Live View Introduction
for details.
Click on the playback window to show the tool bar as shown in area ③; right click on the window to show
the menu list. The tool bar and menu list are introduced in the table below.