User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Record & Disk Management
DVR User Manual
39
➢ Set Week Schedule
Click or and then click “Manual” beside to set the week schedule. Refer to the picture below. Set the start and end time, check
the days in the window and then click “OK” to save the settings.
Click “All” to set all week recording; click “Reverse” to swap the selected and unselected time in a week; click “Clear All” to clear all the selected
area in a week.
7.3.2 Record Schedule Configuration
Click Start→Settings→Record→Record Schedule→Schedule Configuration to go to the interface as shown
below. Set the schedule of sensor record, motion record, timed record and intelligence record. Click “None”
in the drop-down menu to clear the schedule. Click “Apply” to save the settings.
Go to “Edit Schedules” interface and then click to edit the schedule. The settings of “Edit Schedule” are
similar to that of the “Add Schedule”. Click to delete the schedule.