User Manual

Record & Disk Management
DVR User Manual
34
7 Record& Disk Management
7.1 Record Configuration
7.1.1 Mode Configuration
Please format the HDDs before recording (refer to 7.5 Disk Management for details). Click
Start→Settings→Record→Mode Settings to go to the mode settings interface. You can set the record time
under the “Manual Record Settings” and then click “Apply” to save the settings. There are two record
modes: auto mode and manual mode.
➢ Auto Mode
Motion Record: Motion alarm record will be enabled when motion alarm happens.
Sensor Record: Sensor alarm record will be enabled when sensor alarm happens.
Motion Record + Sensor Record: Motion/sensor alarm record will be enabled when motion/sensor alarm
happens.
Continuous Record + Motion Record: Normal record is enabled all the time; motion alarm record will be
started when motion alarm happens.
Continuous Record + Sensor Record: Normal record is enabled all the time; sensor alarm record will be
started when sensor alarm happens.
Continuous Record + Motion Record + Sensor Record: Normal record is enabled all the time; motion/sensor
alarm record will be enabled when motion/sensor alarm happens.
Continuous Record + Motion Record + Sensor Record + Analytics Record: Normal record is enabled all the
time; motion/sensor/analytics alarm record will be enabled when motion/sensor/intelligence analytics alarm
happens.
You can add more auto modes on intelligence record. Click “Advanced” button to pop up a window as shown
below. Check the modes in the window and then click “Add” button to show the modes in the record mode
list (in the window, the checked modes can be showed in the record mode list while the unchecked modes
cannot; you shall check “Analytics Record”).