User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
PTZ
DVR User Manual
30
➢ OSD Setting
Go to PTZ protocol setting interface and then set the protocol before you bring up the OSD. Click “OSD
Menu” to go to camera OSD setting interface. Click to start OSD setting. The meanings of the buttons
are shown in the table below.
Button
Meaning
Click it to call main menu or enter the sub menu or confirm the
settings.
Click it to call main menu or enter the sub menu or confirm the
settings.
Click it to change the menu mode or decrease the menu value.
Click it to change the menu mode or increase the menu value.
Click it to go to the previous menu.
Click it to go to the next menu.
➢ Preset Setting
Click “Preset” to go to preset operation tab and then click “Add” button to pop up a window as shown below.
Select the preset and then enter the preset name in the window; finally click “OK” button to save the settings.
You can add 255 presets for each dome at most.
Adjust the dome’s direction and then click “Save Position” to save the current preset position (you can also
click another preset in the preset list and then save the preset position after adjusting the dome’s direction);
click in the preset list to call the preset; click “Delete” button to delete the selected preset.
You can also go to preset setting interface for preset setting, see 6.2 Preset Setting for details.
➢ Cruise Setting